Hallo, ich habe jetzt eine Anleitung auf

http:www.discriminator.nl/ubc60xlt-2/index-en.html

gefunden

Anscheinend muss ich ja einen Widerstand an den "Pin 9" anlöten. Welchen Widerstand sollte man hier benutzen?

An diesen Widerstand soll man jetzt ein isoliertes Kabel anlöten.

Den nächsten Schritt verstehe ich nicht so ganz:

"The discriminator output contains a rather strong 455 kHz component. By connecting the 10 k resistor to a grounded capacor, a simple lowpass filter is created. I used a capacitor of 2.2 nF, resulting in a cutoff frequency of about 7 kHz. The IF component is surpressed effectively this way. The capacitor is connected to the metal shield of the IF coil, which is grounded.

A 3.5 mm chassis terminal is mounted in the left bottom part of the back panel. This terminal is connected to the capacitor and ground"

Könnte mir eventuell jemand diesen Schritt erklären und sagen, was dahinter steckt? Und wie muss ich jetzt das Kabel bzw die Kabel an den Klinkstecker anschließen? Muss ich die Kabel, die da vorher dran waren, irgendwie entfernen?

Und dann hätte ich noch eine Frage zu dem Mono/Stereo Kabel zum Verbinden mit dem PC! Iist dieses Kabel unbedingt erforderlich? Und wenn ja, warum brauche ich es?
Vielen Dank im Voraus!